Simulation of Kalirejo Road Side Slope based on Altered Andesite Characters, Kulon Progo Regency, Indonesia

https://doi.org/10.22146/jag.56916

Hnin Thandar Phyu(1), Heru Hendrayana(2*), I Gde Budi Indrawan(3), Toshitaka Kamai(4)

(1) Geology Department, University of Yangon and Taungoo University
(2) SCOPUS ID: 56623102400 Departement of Engineering Geology, Universitas Gadjah Mada
(3) Department of Geological Engineering, Universitas Gadjah Mada
(4) Geohazards Research Center on Landslides, DPRI, Uji Campus, Kyoto University, Kyoto
(*) Corresponding Author

Abstract


ABSTRACT. This study is performed to investigate the characteristics of intrusive andesite rock consisting of Kalirejo Road Side Slope located in Kulon Progo Mountains. The rocks consisting the slope are identified by visual observation of hand specimens in the field, petrographic and X-ray Diffraction (XRD) analyses of the rock samples in the laboratory, upon which genetic rock classification is determined. The altered rock types are determined by the presence of specific minerals identified in the petrographic and XRD analyses. The alteration intensity is examined by comparing the amount of secondary minerals to the primary minerals observed in the petrographic and XRD analyses. The developments of rock weathering are determined in the field GSI classification based on the visual characteristics and in the laboratory-based on the Chemical Index of Alteration (CIA) and engineering properties of the altered rocks. The results show that the rocks typically consisted of 33.2 to 59.2% plagioclase, 1.4 to 5.1% quartz, therefore, are classified as andesite. The presence of halloysite, montmorillonite, and kaolinite as secondary minerals in the altered andesite indicated that the parent andesite rocks have undergone argillic alteration. Meanwhile, the percentages of primary minerals to secondary minerals indicate that the andesite rocks have undergone moderate to high alteration intensity. Based on the visual characteristics, the research area consisted of fresh, slight weathered andesite rocks and complete weathered residual soil. The CIA values of the samples are increased with the increase in rock weathering. Identification of visual characteristics of rock weathering appeared to be in good agreement with those classified based on the CIA and engineering properties analysis results. The uniaxial compressive strength (UCS) of rocks and soils is determined by point load tests. Engineering properties of the residual soils are performed by using ASTM standard procedures. In the lower part of the roadside, slope consists of fresh and slightly weathered andesite rocks, which have relatively high strength and are classified as medium strong rocks. Meanwhile, the upper part of the slope profile contained completely weathered residual soil, which had very low compressive strength, are classified as very weak soil.

Keywords:  andesite, argillic alteration, Geological Strength Index (GSI), hydrothermal alteration, roadside slope, weathering

Full Text:

PDF


References

ASTM, D. 3080 (1998) Standard test method for direct shear test of soils under consolidated drained conditions. In American Society for Testing and Materials, (Vol. 100), p.6.

ASTM, D. (2000). 422-63 (Reapproved 1998) Standard Test Method for Particle-Size Analysis of Soils, Annual (2000) Book of ASTM Standards, p.8.

ASTM, D. 2487-00 (2000) Standard Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System), American Society for Testing and Materials, West Conshohocken, p.12.

ASTM, D. 4318-00 (2000) Standard Test Methods for Liquid Limit, Plastic Limit and Plasticity Index of Soils, Reprinted from the Annual Book of ASTM Standards. Copyright ASTM, 4(8), p. 14.

ASTM, D. 854-02 (2002) Standard test method for specific gravity of soil solids by water pycnometer. Annual Book of ASTM Standards. American Society for Testing and Materials, West Conshohocken, p.7.

ASTM, D. 5731-02 (2002) Standard Test Method for Determination of the Point Load Strength Index of Rock. Annual Book of ASTM Standards. American Society for Testing and Materials, West Conshohocken, p.9.

Bell, F.G. (2007) Description, properties and behaviour of soil and rocks, in eds. ButterworthHeinemann, Engineering geology, 2nd Edition Chapter 5, Elsevier Ltd., pp. 249-259.

Bishop, A.W. (1955) The use of the slip circle in the stability analysis of slopes. Geotechnique, 5(1), pp.7-17.

Broch, E. and Franklin, J.A. (1972) The point-load strength test. In International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts (Vol. 9, No. 6, pp. 669-676). Pergamon.

Byer, F. M. (1990) Procedure for determination of volume constituents in thin section of rocks, Los Alamos National Laboratory, Yucca Mountain Project, p. 8.

Frohlich, O. K. (1955) General theory of the stability of slopes. Géotechnique, 5, 37–47.

Hoek, E. (2007) Rock Mass Properties : In Practical Rock Engineering, Canada, pp.1-47.

ISRM (1981) in Hoek, E. (2007). Rock mass properties: practical rock engineering, Chapter 11, pp.195.

ISRM (2007) in Martin, D. and Stacey, P. (2018) Guidelines for Open Pit Slope Design in Weak Rocks, pp. 15.

Nesbitt, H.W. and Young. G.M. (1982) Early Proterozoic climates and plate motions inferred from major element chemistry of lutites. Nature, 299, pp. 715-717.

Novianto, M.W.A., Djaja, Wahyudin (1997) Peta Geologi Teknik Lembar Yogyakarta, Skala 1 : 100.000, Bandung, Direktorat Geologi Tata Lingkungan.

Phyu, H. T. (2020) Stability of altered intrusive rock slopes in Kulon Progo Mountains, Yogyakarta Special Region, Indonesia (Unpublished doctoral dissertation). Geological Engineering Department, Faculty of Engineering, Universitas Gadjah Mada, Indonesia, p. 248.

Pratama, D. A. P., Indrawan, I. G. B. and Warmada, I W. (2018) Mineralogical Characteristics of Hydrothermally-altered Andesite in Kalirejo Village and The Surrounding Areas, Indonesia. Journal of Applied Geology, 3(2), pp. 48-57. DOI: 10.22146/jag.48598

Rahardjo, W., Sukandarrumidi and Rosidi, H. M. D. (1995) Geological Sheet Map of Yogyakarta, 1 : 100.000, Directory of Geology, Bandung, Indonesia.

RocScience, Inc. Slide-6.005 (2019). Two-dimensional slope stability analysis for soil and rock slopes.

Sivakugan, N., Shukla, S. K. and Das, B. M. (2013) Rock slope stability, in eds. Taylor & Francis Group, Rock mechanics: an introduction, Crc Press, pp. 187-213.

Streckeisen, A. (1978) IUGS Subcommission on the Systematics of Igneous Rocks. Classification and Nomenclature of Volcanic Rocks, Lamprophyres, Carbonatites and Melilite Rocks. Recommendations and Suggestions. Neues Jahrbuch fur Mineralogie. Stuttgart. Abhandlungen, Vol. 143, pp. 1-14.

Terzaghi, K., Peck, R. B. and Mesri, G. (1996) Stability of slope, John Wiley & Sons, Soil mechanics in engineering practice, 3rd Edition, Chapter 5, A Wiley Interscience Publication, pp. 267-271.



DOI: https://doi.org/10.22146/jag.56916

Article Metrics

Abstract views : 711 | views : 658

Refbacks

  • There are currently no refbacks.


Copyright (c) 2021 Journal of Applied Geology

Journal of Applied Geology Indexed by:

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License